HiRO H50113 V92 56K - Manual (Page 32)

Hiro H50113
31
W<value>—Result Code Option
Use this command to select the modems CONNECT message
options.
Result codes:
_ OK if <value> = 0—2.
_ ERROR if <value>
≠0—2.
Command Function
W0 CONNECT result code reports DTE receive speed.
Disables protocol result codes.
W1 CONNECT result code reports DTE receive speed.
Enables protocol result codes.
W2 CONNECT result code reports DCE receive speed.
Enables protocol result codes (default).
Z<value>—Reset and Recall Stored Profile
Use this command to make the modem go on-hook and restore
the profile saved by the last &W command.
Note: Both Z0 or Z1 restore the same profile
OK if <value> = 0—1.
_ ERROR if <value>
≠0—1.