HiRO H50113 V92 56K - Manual (Page 29)

Hiro H50113
28
N<value>—Modulation Handshake
Use this command to set the modem protocol for handling
handshake negotiation at connection time if the communication
speed of the remote modem is different from the speed of the
local modem.
Result codes:
_ OK if <value> = 0—1.
_ ERROR if <value>
≠0—1.
O<value>—Return to On-Line Data Mode
Use this command to exit on-line command mode and reenter
on-line data mode. If the modem is not in on-line
command mode when this command is received the modem
generates an ERROR result code.
Result codes:
_ CONNECT if <value> = 0, 1, 3 and the result code and call
progress monitor is set to 0 (X0).
_ CONNECT <rate> if <value> = 0, 1, 3 and the result code and
call progress monitor is not set to 0 (X<value>
where n = 1—7).
_ NO CARRIER if the connection is not successfully resumed.
_ ERROR if <value>
≠0—1, 3.