INFICON MicroFID II Portable Flame Ionization Detector - Manual (Page 22)

074-579-P1A 22
Using the MicroFID II Battery Charger
READ THESE INSTRUCTIONS BEFORE USING THE CHARGER
The MicroFID II battery charger is only designed for indoor use
and should not come into contact with water or dust. In order to
avoid overheating, the charger should not be covered when it is
in use.
The charger is turned on by connecting it to the mains socket.
Disconnecting it from the mains socket turns the charger off. If
the charger is equipped with a mains cord, verify that the cord
has not been damaged. If the cord is damaged, the charger
must not be used.
The charger contains dangerous voltages and the cover should not be removed.
CHARGER FUNCTIONALITY
This charger is a fast charger for NiMH batteries. The charger will automatically charge the battery at a
fast rate, and then charge to a slow rate near the end of the cycle. This prevents over-charging.
CAUTION: Do not charge batteries at too high or too low temperatures. Charge only in areas between
38-110°F (3-43°C).
MicroFID II with probe in probe
holder position MicroFID II with probe in
telescoping position