INFICON XTC/C Thin Film Deposition Controller - Manual (Page 38)

2 - 10
IP
N 07
4-
18
3X
XTC/C - XTC/2 Operating Manual
2.4 XTC/2 Front Panel Description
The description of the XTC/2 front panel is divided into two sections, the display
area and the front control panel.
Figure 2-6 Front Panel XTC/2
2.4.1 XTC/2 Front Control Panel Description
1— LCD DISPLAY
Highly visible display of current information. See section 2.4.2 on page
2-12 for details.
2— LIFE
Pressing the 1 key momentarily switches the display to percent of crystal
life used, software version, crystal frequency, and S and Q values, when
the display is in the operate mode.
3— ZERO
Pressing the 2 key zeros the displayed thickness when the display is in the
operate mode.
4— XTSW
Crystal Switch. Pressing the 3 key advances the CrystalSix to the next
available crystal or changes the active crystal of the dual head when the
display is in the operate mode. (See
section 4.15.1 on page 4-25 .)
5— MPWR
Manual. Pressing the 4 key places the unit in manual power control or rate
control mode when the display is in the operate mode.
6— START
Initiates action. (Starts State Sequencing, see Figure 4-2 on page 4-2 and
Figure 4-3 on page 4-3 .)
7— STOP
Halts State Sequencing, see Figure 4-2 on page 4-2 and Figure 4-3 on
page 4-3 .
8— PROG
Program. Toggles the display between the program and operate modes.
1 2 3 4 5 6
7
8
9
10 11 12 13 14 15 16 17
18