Intelix DIGI-HD-COAX2-R - Manual

8001 Terrace Ave
Suite #201
Suite #201
Middleton, WI 53562
Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833
DIGI-HD-COAX2 Installation Guide
The Intelix DIGI-HD-COAX2 is an AV transport system that allows
HDMI with multi-channel audio to be distributed using coaxial
cable. Transmission distances can be seen in the following table.
The transmitter features selectable EDID presets to allow for
stereo, 5.1, or 7.1 audio systems, and dual outputs. The receiver
features a loop out to allow the signal to be daisy-chained up to 7
receivers.
DIP Switch Settings
DIGI-HD-COAX2 DIP Switch Positions
DIP Setting Mode
2 Channel Audio – Set DIPs to this
configuration to enable audio for
stereo speaker systems. Use this for
connecting to flat panel TVs.
6 Channel Audio – Set DIPs to this
configuration to enable audio for 5.1
speaker systems. This will also allow
stereo.
8 Channel Audio – Set DIPs to this
configuration to enable audio for 7.1
speaker systems. This will also allow
stereo and 5.1 content.
Model Numbers
Transmitters:
DIGI-HD-COAX2-S – Transmitter for use in North America
DIGI-HD-COAX2-S-EU – Transmitter for use in Europe
DIGI-HD-COAX2-S-UK – Transmitter for use in the United Kingdom
DIGI-HD-COAX2-S-AU – Transmitter for use in Australia
Receivers:
DIGI-HD-COAX2-R – Receiver for use in North America
DIGI-HD-COAX2-R-EU – Receiver for use in Europe
DIGI-HD-COAX2-R-UK – Receiver for use in the United Kingdom
DIGI-HD-COAX2-R-AU – Receiver for use in Australia
Installation Instructions
1. Turn off power and disconnect the audio/video
equipment by following the manufacturer’s
instructions.
2. Adjust DIP switches for desired mode.
3. Connect all coaxial cables.
4. Install included 75ohm Terminator to the unused
“Loop Out” on the receiver.
5. Connect all HDMI cables.
6. Connect and energize power supplies.
7. Power on attached audio/video devices, and
select the correct HDMI input.
8. Confirm audio and video on all displays.