Intelix AVO-VGA2-WP-R - Manual

Intelix AVO-VGA2-WP
Installation Manual
Introduction
The Intelix AVO-VGA2-WP balun set transmits VGA video and stereo audio passively
over two standard unshielded twisted pair cables, such as Cat 5, Cat 5e, or Cat 6. The unit
eliminates costly and bulky cable while extending transmission distances.
One twisted pair cable carries the audio path and a second twisted pair cable carries the
video path, thereby allowing audio and video to be transmitted to two separate locations.
Pre-Installation
Note: The AVO-VGA2-WP does not support VGA handshaking and control
signals. Therefore, it is necessary to set the monitor attributes prior to installing the
balun set. First connect the source (typically a computer) directly to the destination
(typically a monitor) with a standard VGA cable. After doing so, set the monitor
attributes to the required settings (i.e., resolution, color, etc.). For best results, also set
the contrast and brightness to the maximum level.
Caution: Do not attempt to disassemble or alter the balun housing. There are no
user-serviceable parts inside the unit. Doing so will void your warranty.