Intelix AVO-VGA2-WP-R - Manual (Page 2)

Installation
1. Power off the source and destination devices which will be connected to the baluns.
2. Verify the modular outlets and cross connects to which you will connect the AVO-
VGA2-WP are configured properly and labeled appropriately to identify the circuit.
3. Verify the desired twisted pairs are not being used for other LAN or telephone
equipment.
4. Connect the send balun (AVO-VGA2-WP-S) to the audio/video ports of the source
equipment. Tighten the mounting screws on each balun.
5. Connect the send balun to the twisted pair cables. Verify the termination conforms to
the EIA/TIA 568B standard.
6. Connect the receive balun (AVO-VGA2-WP-R) to the destination equipment.
7. Connect the receive balun to the opposite end of the twised pair cables. Verify
the termination conforms to the EIA/TIA 568B standard.
8. Power on the source and destination equipment.
9. If necessary, set monitor contrast and brightness to the desired levels.
10. Set the monitor refresh rate to the optimal rate for the display at the desired resolution.
11. If necessary, adjust the image quality with the Sync switch on the send and receive
baluns. It is recommended that both switches be in the same position. Position A
unbalances the signal (demux), position B balances the signal (mux).
Caution: Do not connect the balun to a telecommunication outlet wired to
unrelated equipment. Doing so may damage the unit or any connected equipment.
Ensure all connected twisted pair cabling is straight-through (point-to-point).
Caution: To minimize the possibility of equipment damage from electrostatic
discharge (ESD), all source and destination equipment must be powered off during
installation. This includes signal extenders, splitters, and switches.
Note: For your convenience, it is recommended that you uniquely mark the ends
of the twisted pair cable before pulling them through a wall or conduit.
Note: The AVO-VGA2-WP features an optional grounding screw that may be used to
correct any image anomalies, such as differences in hue from one side of a monitor to
the next. Should this occur, connect the balun ground to earth ground. However, if the
building has a grounding problem, such as ground loops, grounding the balun may
negatively affect the signal. Only ground the AVO-VGA2-WP if it positively affects
the signal.