Intelix AVO-USB-H - Manual (Page 2)

Installation
1. Power off the source and destination devices which will be connected to the
extenders.
2. Verify the modular outlets and cross connects to which you will connect the AVO‐USB
are configured properly and labeled appropriately to identify the circuit.
3. Verify the desired twisted pairs are not being used for other LAN or telephone
equipment.
4. Connect the AVO‐USB‐H to the USB port of the host device, typically a computer.
5. Connect one end of the twisted pair cable to the send extender. The RJ45 pinout in
the twisted pair cabling should conform to the EIA/TIA 568A or 568B standard.
6. Connect a compatible transmitter to the client device, typically a keyboard or mouse.
7. Connect the other end of the twisted pair cable to the receive extender. The RJ45
pinout in the twisted pair cabling should conform to the EIA/TIA 568A or 568B
standard.
8. Power on the source and destination equipment.
Caution: Do not connect the extender to a telecommunication outlet wired
to unrelated equipment. Doing so may damage the unit or any connected
equipment. Ensure all connected twisted pair cabling is straight-through
(point-to-point
).
Caution: To minimize the possibility of equipment damage from
electrostatic discharge (ESD), all source and destination equipment must
be powered off during installation. This includes signal extenders, splitters,
and switches.
Note: For your convenience, it is recommended that you uniquely mark
the ends of the twisted pair cable before pulling them through a wall or
Note: The AVO-USB supports speeds up to 12 Mbps. Distance is
dependent on transmission speeds. Please refer to the technical
specifications for maximum distances.