JUMO 705021 mTRON T - Analog Input Module, 8-Ch. Operating Manual - Manual (Page 18)

3 Installation
18
Dismounting, using the example of a multichannel controller module 705010
Removing the multichannel controller module from the DIN rail
Procedure:
(C2)
(D1)
(A4) (B3)
(C)(D) (A) (B)
Step Activity
1 Fully release the end bracket (D) using a screwdriver (D1), press upward from below, pivot
toward the front, and remove from the DIN rail.
Note: The end bracket does not need to be removed from the DIN rail if there is sufficient
space to the side to move it at least 20 mm to the right.
2 Move the cover (C) to the right (C2) until the side contacts of the neighboring module are
exposed. Then release the cover at the bottom using a screwdriver, press upward, and
remove from the DIN rail.
Note: The cover does not need to be removed from the DIN rail if there is sufficient space
to the side to move it at least 20 mm to the right.
(A)
(F)
(E)
(E5)
(F7)
(A6)
(A8)