JUMO 705020 mTRON T - Analog Input Module, 4-Ch. Operating Manual - Manual (Page 35)

35
6 Configuration
Linearization Available options and factory settings depend on the measuring probe selected
Linear
Pt50 GOST 6651-94
Pt100 DIN EN 60751
Pt500 DIN EN 60751
Pt1000 DIN EN 60751
Pt100J JIS 1604
Pt100G GOST 6651-94
KTY Type KTY11-6
Cu50 GOST 6651-94
Cu100 GOST 6651-94
Ni100 DIN EN 60751
NiCr-CuNi_E DIN EN 60584
Cu-CuNi_T DIN EN 60584
Fe-CuNi_J DIN EN 60584
Cu_CuNi_U
Fe-CuNi_L
NiCr-Ni_K DIN EN 60584
Pt10Rh-Pt_S DIN EN 60584
Pt13Rh-Pt_R DIN EN 60584
Pt30Rh-Pt6Rh_B DIN EN 60584
NiCrSi-NiSi_N DIN EN 60584
W5Re-W26Re_C
W3Re-W25Re_D
W3Re-W26Re
Chromel-Copel GOST 8.585-2001
Chromel-Alumel GOST 8.585-2001
Platinel II
Customer-specific Customer-specific linearization using
grid points (pairs of values) or 4th order
polynomial
Measuring range
start Factory setting depends on sensor and linearization.
-99999 to +99999 Start value of the measuring range (for
resistance transmitter, standard signal,
and potentiometer) to detect out of
range
Measuring range
end Factory setting depends on sensor and linearization.
-99999 to +99999 End value of measuring range (see
above) to detect out of range
Parameter Selection/settings Description
?
?
?