JUMO 707050 dTRANS T05 - Programmable 2-Wire Transmitter Operating Manual - Manual (Page 58)

5 Configuration
20
5.2 Setup program
The transmitter is configured on the PC with the setup program. The connection between trans-
mitter and PC is established via a USB cable. The transmitter interface is a USB port of the
Mini-B type. It supports standard 2.0 "Full Speed". Once configuration of the transmitter has
been completed make sure that the attached hinged-on lid is back on the transmitter's USB in-
terface.
Configurable parameters
Sensor type
Connection type 2/3-wire circuit or 4-wire circuit for RTD temperature probes or
resistors/potentiometers
Linearization
Customer-specific linearization
Sensor factor for thermocouple/RTD temperature probe
Lead wire resistance with 2-wire circuit
External or internal cold junction for thermocouple
Scaling
Digital filter
Offset
Unit
Behavior in the event of a probe break/short-circuit
Output signal increasing or decreasing (reversion)
Output functions, current 4 to 20 mA
Type 705050 and type 705051 4 to 20 mA scalable (start/end)
Constant current source
Output functions, voltage 0 to 10 V
Only type 705051 0 to 10 V scalable (start/end)
Constant voltage source