KD Scientific Gemini 88 - Manual (Page 15)

13
KDS Gemini 88
Valve Control Box
Setting up Valve
Set up consists of:
1) Pump to Valve Electrical Connections:
The cable fitted with a male 9 pin D-sub connector must be connected to the
female D-sub connector on the rear of the Model 33 Syringe Pump. The Valve
Power can now be swiched on with the illuminated power On/Off switch on the
front valve housing.
2) Valve tubing to syringe hook up:
The valve(s) are de-energized when the front mechanism (#1) is running in the
INFUSE direction. The syringe on the #1 mechanism when infusing should
therefore be connected to the lower tubing in the pinch valve (see figures on
next page).
Continuous Delivery Valve Boxes
Model No. Description
55-7000 Pump 33 Continuous Delivery Valve Box, normal pressure, 30 p.s.i. supplied with
3.2 mm ID X 6.4 mm OD (1/8” ID X 1/4” OD) silastic tubing and a connector
cable for connection to the syringe pump.
55-7001 Pump 33 Continuous Delivery Valve Box, high pressure, 200 p.s.i. supplied with
6.4 mm (1/4) OD stainless steel tubing with SWAGELOK ® fittings and connector
cable for connection to the syringe pump.