KD Scientific Gemini 88 - Manual (Page 8)

6
KDS Gemini 88
Initial Setup
1) Read the manual.
2) Locate the voltage selector switch on the rear panel of the pump and set it to the
voltage being used. If other than 115VAC, 60 Hz is being used, the plug must be
cut off and an appropriate plug installed, observing the polarity of the international
line cord used:
Brown – high
Blue – neutral
Green – ground
3) Turn on main power switch located directly above the line cord on the rear panel.
The display will illuminate indicating that the power connections are correct. The
flashing display indicates that power has just been applied.
4) Load syringes.
5) Set syringe ID
6) Set pumping rate(s)
7) Select the run mode
8) Selecting the pump direction
See section on operation for more information