Landoll 4630-36 Folding Seeder Operators Manual v.F-640-0313 03/2013 - Manual (Page 13)

3-1
Chapter 3
Assembly Instructions
Your new 4630-36 Folding Seeder comes nearly
completely assembled from the factory and ready to go to
the field.
To insure alignment of assemblies, leave the nuts loose
until completion of final assembly. Use lock washers or
flat washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts
evenly to prevent misalignment, distortion or binding.
Tighten all screws and nuts to the recommended torques
(See Table 2-1 on page 2-2.)

WARNING

DANGER

CAUTION
Do not attempt to lift heavy parts (such as the
frame, wheel lift, and pull hitch) manually. Use a
hoist or a forklift to move these parts into
position.
To prevent accidental lowering:
• All hydraulically elevated equipment must be
locked out using the cylinder lockouts.
• Lower equipment to the ground while
servicing or when it is idle.
• Failure to take measures to prevent
accidental lowering may result in serious
personal injury or death.
Be sure to bleed the hydraulic system of all air in
lines after installation. Failure to bleed the system
of all air can result in improper machine
operation.