Landoll SL/SLB/SLP/SLPB/SLPB TURFMAKER III - Manual (Page 34)

2-24 1P124
ASSEMBLY INSTRUCTIONS
Figure 2-31: Rear Seedbox Addition (4 of 4)
15. Screw the front and rear left and right hand seed
shafts together. Do not tighten couplings at this time.
Sight along seedboxes from ends, front and rear to
ensure seedboxes are straight and level and tighten the
boxes to the transmission mounting plate, then to center
mounting bracket and then to the right hand mounting
bracket. Next tighten the mounting brackets to frame.
16. Assemble front and rear seed shaft rate adjustment
parts onto seed shafts.
17. Adjust seedcups and tighten seed shaft couplings.
Completely close all seed cups (meters). Set rate
adjustment sleeve and nuts to correct settings.
13. Install RH Rear Seedbox.
Front
Rear
Bearing Carrier
Adjusting
Screw
Seed Rate
Adjusting
Nut
Flangette
Flangette
Lock Nut
1/2-13
Lock Nut
1/2-13
14. Mount New RH End Bracket
And Light Brackets (8-ft And
10-ft Models).
Rear
Coupling
Bearing
Bearing
Hex Nut,1-8