Landoll SL 8, 10, 12 Turfmaker Seeder - Manual (Page 22)

2-12 1P342
ASSEMBLY INSTRUCTIONS
Agitator Kit (Optional)
1. Remove knock-outs for 3/4” flangette bearings.
These are located at each end and center of seed
box assembly. Hole patterns are as shown below:
Figure 2-12: Hole Patterns
2. Install bearings and 1/4” thick spacer at left end of
seedbox.
3. Install left end shaft and 19 tooth sprocket:
8 ft. 3K436, 3/4 x 5 1/4”
10 ft. 1K197, 3/4 x 5 1/4”
12 ft. 1K197, 3//4 x 5 1/4”
End of shaft with the smaller hole is for the sprocket and
roll pin. Align sprocket with unused lower sprocket
already in transmission.
4. Install one of the agitators (they are all the same per
kit) on the left shaft.
5. Install one of the center shafts in the agitator from
Step 4.
6. Install the second agitator.
7. Install center bearing and shaft.
8. Complete assembly in a similar manner for the right
hand box.
9. Tighten locking collars in direction of rotation
(counter-clockwise when viewed from the right end of
machine).
10. Rotate agitator assembly to be sure it turns freely.
11. Install drive chain. Long ends of the connector pins
for both chains should point away from each other to
prevent interference.
12. Check chain tension bar to be sure it aligns very
closely with chain. Bend slightly if needed and install.
13. Adjust chain tension so both strands of chain are
nearly taut.
2 3/16”
Diameter
3/8” Diameter