Landoll SL 8, 10, 12 Turfmaker Seeder - Manual (Page 27)

ASSEMBLY INSTRUCTIONS
2-17
Figure 2-18: Electronic Acre Meter (3 of 3)
4. Adjust the pickup switch and bracket so the
centerline of magnet wheel and pick up switch are
horizontally and vertically aligned with maximum 1/8”
between magnet wheel and pick up switch. Firmly
tighten all screws. See Figure 2-18.
NOTE
Alignment of the pickup switch and magnet wheel is
critical. Improper alignment will cause the acre counter to
record acres erratically or not at all.
5. Attach the short pickup switch ground wire to the
small hole in the 5K714 bracket with a #6-32 x 1/2”
machine screw, removing paint under the wire
connector to assure a good electrical ground
connection. See Figure 2-18.
6. Route the wire from the acre meter down the front of
the seed box to the pickup switch and connect the
mating plugs.
7. Securely fasten the wire to the seed box and
transmission drive using the adhesive mounting
bases and wire ties to prevent wire from becoming
entangled or rubbing moving parts.
See page 3-7 for Acre Meter programing instructions.
1/8”
Maximum
Pick Up Switch
Pick Up Switch
Magnet Wheel
Ground Wire
5K714 Bracket
Magnet Wheel