Landoll XL144/XLC144/XLD144/XLH144/XLO144 X-Fold Pulverizer - Manual (Page 7)

5J801 182rev501 Page 4A
Safety Signs & Decals
There are three levels of hazard intensity that appear with the safety alert symbol on safety decals: DANGER,
WARNING, and CAUTION. The level of hazard intensity is determined by the following definitions:
DANGER - Immediate hazards which WILL result in severe personal injury or death.
WARNING - Hazards or unsafe practices which COULD result in severe personal injury or death.
CAUTION - A reminder of safety practices, or an alert to unsafe practices which could result in
personal injury.
Examine safety decals and be sure you have the correct safety decals for the machine. Keep these signs
clean so they can be observed readily. It is important to keep these decals cleaned more frequently than the
machine. Wash with soap and water or cleaning solution as required.
Replace decals that become damaged or lost.
Order decals through your BRILLION dealer.
When applying decals to the machine, be sure to clean the surface to remove any dirt or residue. Where
possible, sign placement should protect the sign from abrasion, damage, or obstruction from mud, dirty oil, etc.
These are the safety decals provided for the pulverizer. (Their locations are illustrated on the next page).
DANGER
FALLING WINGS CAN CAUSE INJURY
OR DEATH. STAND CLEAR WHEN WINGS
ARE BEING RAISED OR LOWERED.
3J675
DANGER
BLEED THE AIR FROM WING LIFT CYLINDERS
BEFORE OPERATING. FAILURE TO DO SO WILL
ALLOW WINGS TO FREE-FALL AND MAY CAUSE
SERIOUS PERSONAL INJURY. SEE OPERATOR’S
MANUAL FOR CORRECT PROCEDURE.
3J678
CAUTION
1. DO NOT ALLOW ANYONE TO RIDE ON THIS IMPLEMENT.
2. DO NOT TRANSPORT AT SPEEDS OVER 20 MPH.
3. DO NOT STAND BETWEEN TRACTOR AND IMPLEMENT WHILE TRACTOR IS MOVING.
4. WHEN SERVICING IN RAISED POSITION, PLACE BLOCKING UNDER ROLLERS.
5. WITH WINGS FOLDED AND WEIGHT ON CENTER ROLLER, THE IMPLEMENT IS
DRAWBAR LIGHT.
5J859
WARNING
DO NOT GO NEAR LEAKS
HIGH PRESSURE OIL EASILY PUNCTURES
SKIN CAUSING SERIOUS INJURY,
GANGRENE OR DEATH.
IF INJURED, SEEK EMERGENCY MEDICAL
HELP. IMMEDIATE SURGERY IS
REQUIRED TO REMOVE OIL.
DO NOT USED FINGERS OR SKIN TO
CHECK FOR LEAKS.
LOWER LOAD OR RELIEVE HYDRAULIC
PRESSURE BEFORE LOOSENING FITTINGS.
10813A
3J675 3J678
5J859
3K706
5J860
IMPORTANT
1. READ AND FOLLOW OPERATING INSTRUCTIONS IN THE MANUAL.
2. WHEN CHANGING FROM TRANSPORT POSITION TO FIELD POSITION, UNFOLD WINGS
COMPLETELY, THEN REVERSE THE HYDRAULIC LEVER TO ALLOW REMOVAL OF THE
CYLINDER TRANSPORT LOCK. AFTER THIS THE IMPLEMENT MAY BE COMPLETELY
LOWERED.
3. WHEN CHANGING FROM FIELD POSITION TO TRANSPORT POSITION, RAISE CENTER
SECTION COMPLETELY WITHOUT FOLDING THE WINGS. THEN INSTALL CYLINDER
TRANSPORT LOCK BEFORE FOLDING THE WINGS.
5J860
528934
528933