Landoll 876 Series Wing Tilloll - Manual (Page 27)

ASSEMBLY INSTRUCTIONS
3-11
Hydraulic Lift Installation
(876-40-H)
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Install the master cylinder on the main frame ports
up, using clevis pin and cotter pins. Connect rod to
gauge wheel arm or rockshaft using cylinder pin bolt
and 1/2 split lock washer.
NOTE
Always adjust the slave cylinder extended length to
measure the same as the master cylinder to allow the
unit to operate level in the field (See Table 3-2 and
Figure 3-7 .)
2. Install the slave cylinders on the wing frame ports up,
using clevis pin and cotter pins. Connect rod to
gauge wheel arm or rockshaft using cylinder pin bolt
and 1/2 split lock washer.
3. Install 90
o
adapters into base and rod end of each lift
cylinder.
IMPORTANT
All cylinder ports are plugged. Do not forget to
remove all plugs and replace with hoses or fittings
before applying hydraulic pressure to cylinders.
Table 3-2: Hydraulic Lift Hose Installation (876-40-H)
ITEM PART NO. HOSE LENGTH (MODEL USED)
A 1-397-010301304 1/2 X 304
B 162782 1/2 X 469
C 1-397-010301184 1/2 X 184
D 151014 1/2 X 500