Field operation, Figure 4-3: adjusting unit working depth, Caution – Landoll 876 Series Wing Tilloll User Manual
Page 48

4-4
F-143-0211 Edition
OPERATION AND MAINTENANCE
Field Operation
1.
Raise the unit to take the weight off of the transport
locks. Remove the transport locks from the lift
cylinders (on the main frame only) (See Figure 4-2.)
2.
Unfold the wings and extend the fold cylinders
completely (See Figure 4-2.)
IMPORTANT
When folding or unfolding wings, operate tractor
engine at a fast idle on 30’, 35’, 40’ units, and hold
hydraulic valve on tractor open to assure smooth
operation.
CAUTION
3.
Check the front to rear leveling of the frame. Adjust
radius rod until frame is level at working depth and all
sections of the machine are cutting at the same
depth (See Figure 4-3.)
Figure 4-3: Adjusting Unit Working Depth
Drive at reasonable speeds to insure your safety.
Slow down before making sharp turns or using
the brakes. Drive slowly over rough ground, side
hills, and around curves to avoid tipping.
RADIUS ROD
ASSEMBLY
xadj-depth