Landoll 876 Series Wing Tilloll - Manual (Page 43)

ASSEMBLY INSTRUCTIONS
3-27
Lubrication
The 876 Series Wing Tilloll must be lubricated before
using it for the first time, and at regular intervals
thereafter. Use a standard multi-purpose grease. See
“Lubrication” on page 4-9 to lubricate your 876 Series
Wing Tilloll.
Decal Placement
Decals are extremely important for naming purposes and
for alerting others to the presence of the machine.
PLACE ALL DECALS on the Tilloll as shown in Figure
3-15. Center them as nearly as possible between the top
and bottom on the frame bar. Sometimes, shank spacing
may position a tool frame too near the end of the frame
bar to place a reflective tape square exactly as shown.
Then place the square between the U-bolts on the tool
frame as near the proper location as possible. A red
reflective square is attached to the rear of the left- and
right-hand end tool frames at the factory. If any decals
become unreadable, or are destroyed during use, get
replacement decals from your Landoll dealer as soon as
possible, and replace them on the machine.