Lenze SDSGA - Manual (Page 21)

Electrical installation
Attachments
5
l
21 BA 13.0008 − EN 2.1
5.1 Attachments
{
Danger!
Ensure that the drives are disconnected from the power supply when working
on them!
(
Stop!
ƒ Unload motors or secure load applied to the drive.
ƒ Do not use hammers or other heavy tools for assembly or disassembly!
Motors with B−side attachments (brakes and/or encoders) are assembled, electrically
connected and tested for operation. Observe the corresponding Operating Instructions!
5.2 Gearbox mounting
(
Stop!
ƒ Do not exceed the permissible radial and axial forces to avoid damage to the
bearings!
ƒ All shaft seals must be generally equipped with a mounting sleeve to avoid
damage to the seal lips.