Lenze E84AYCER - Manual (Page 78)

E84AYCER communication manual (PROFINET)
Parameter reference
Parameters of the communication module
78
L
EDS84AYCER EN 2.0 - 11/2010
13 Parameter reference
This chapter supplements the parameter list and the table of attributes in the software
manual and in the »Engineer« online help for the Inverter Drive 8400 by the parameters of
the E84AYCER communication module (PROFINET).
13.1 Parameters of the communication module
This chapter lists the parameters of the E84AYCER communication module (PROFINET) in
numerically ascending order.

Software manual/»Engineer« online help for the Inverter Drive 8400
General information on parameters is provided here.

Note!
PROFINET command "Reset to factory defaults"
If the "Reset to factory defaults" PROFINET command is executed by a supervisor
or an IO controller, the PROFINET-specific parameters will be reset to their
standard values:
•
C13000 | IP address
• C13001 | Subnetwork mask
• C13002 | Gateway address
• C13010 | Active IP address
• C13011 | Active subnetwork mask
• C13012 | Active gateway address
• C13864 | Active station name
• C13899 | Station name
• C13910 | I&M1 system designation
• C13911 | I&M1 installation site
• C13912 | I&M2 installation date
• C13913 | I&M3 additional information
• C13914 | I&M4 signature code