Lenze E94AZMS0314 - Manual (Page 42)

5 Mechanical installation
Important notes
EDK94AZMS DE/EN/FR/ES/IT 8.0 42
l
H1_MechINS−Fi NbMontage_GG2−3_EN
5 Mechanical installation
Important notes
ƒ The mounting location must always comply with the operating conditions specified
in the technical data ( ^ 38). Take additional measures if necessary.
ƒ The mounting plate of the control cabinet must have the following properties:
– electrically conductive
– free of lacquer
ƒ The mechanical connections must always be ensured.
ƒ A free air circulation must be ensured for dissipating the heat.
)
Note!
The filter can be mounted in two different variants. This results in differing
mounting dimensions.
ƒ Standard mounting
– The filter is mounted below the mounting base of the basic device. The
grid hole pattern of the L−force 9400 device series can be used.
ƒ Side−by−side mounting for small control cabinet depth
– Device size I: The filter is mounted left to the basic device. The grid hole
pattern of the L−force 9400 device series can be used.
– Device sizes II and III: The filter is turned by 90° and mounted left to the
basic device. The grid hole pattern of the L−force 9400 device series
cannot be used.
)
Note!
For standard mounting and side−by−side mounting of size I devices, observe
that the effective thread length of the two integrated lower fastening screws
is 5 mm. The fastening thread therefore must start directly at the contact
surface to ensure a friction−locked connection and full−surface contact of the
filter.
For side−by−side mounting of size II and III devices, these screws are not used.