Lenze E82ZN - Manual (Page 38)

Electrical installation
Wiring
6
l
38 EDK82ZN903 DE/EN/FR 5.1
6.4 Wiring
(
Stop!
ƒ Observe the Mounting Instructions for the basic device when wiring the
mains filter.
ƒ Ensure permanent electrical connections.
L
0
2
1
3
8200vec106
0 Connection cables "load"
1 Screw terminals "thermostat"
2 PE stud
3 Screw terminals "line"
How to wire the filter:
1. Connect the connection cables "load"
0 to the basic device.
– Observe the Mounting Instructions for the basic device!
2. Wire the terminals of the thermostat
1.
– Observe tightening torque!
– Switching capacity: 250 V AC / 1.6 A (NC contact)
– Integrate the thermal contact into the monitoring system so that the mains supply
is switched off when the filter is overheated.
3. Attach the PE conductor to the PE stud
2 with the ring cable lug.
– Observe tightening torque!
4. Connect the mains cables to the screw terminal "line"
2.
– Observe tightening torque!