Lenze E82xV113Kxxxxx - Manual (Page 16)

Parameter setting
Parameter setting with E82ZBC keypad
Display elements and function keys
2
l
16 EDK82EV113 EN 4.0
Explanation Meaning Display
3 Bar graph display
Value set in C0004 in %
(Lenze setting: Device utilisation C0056) Display range: − 180 % ... + 180 %
(1 mark = 20 %)
4 Parameter set display
In the
g
mode:
Display of the parameter set activated via
digital signal
Otherwise:
Display of the parameter set active for
changing Select the individual parameter sets in the
m
mode
in the function bar 2
5 Code number display
6 Subcode number display
7 Display of parameter value or fault message
Function keys
Pos. Key Function Explanation
8 Function keys
u Enable controller For operation with a function module, the X3/28
terminal must be set to HIGH level.
s Inhibit controller (CINH) or quick stop (QSP) Configuration in C0469; inactive if the standard
device is running in manual mode (C0410/17)
t Change between function bar 1 « function
bar 2
xw To the right/left in the active function bar The active function is framed.
zy Increase/decrease value
Quick change: Keep the key pressed Only blinking values can be changed.
v Store parameters if p is blinking
Confirmation by STOre in the display