Lenze E82xV113Kxxxxx - Manual (Page 8)

Safety instructions
General safety and application notes for Lenze controllers
1
l
8 EDK82EV113 EN 4.0
1 Safety instructions
1.1 General safety and application notes for Lenze controllers
(in accordance with Low−Voltage Directive 2006/95/EC)
For your personal safety
Depending on their degree of protection, some parts of the Lenze controllers (frequency
inverters, servo inverters, DC speed controllers) and their accessory components can be
live, moving and rotating during operation. Surfaces can be hot.
Non−authorised removal of the required cover, inappropriate use, incorrect installation or
operation, creates the risk of severe injury to persons or damage to material assets.
For more information, please see the documentation.
High amounts of energy are produced in the controller. Therefore it is required to wear
personal protective equipment (body protection, headgear, eye protection, ear protection,
hand guard).
All operations concerning transport, installation, and commissioning as well as
maintenance must be carried out by qualified, skilled personnel (IEC 364 or
CENELEC HD 384 or DIN VDE 0100 and IEC report 664 or DIN VDE 0110 and national
regulations for the prevention of accidents must be observed).
According to this basic safety information, qualified, skilled personnel are persons who are
familiar with the assembly, installation, commissioning, and operation of the product and
who have the qualifications necessary for their occupation.
Application as directed
Controllers are components which are designed for installation in electrical systems or
machines. They are not to be used as domestic appliances, but only for industrial purposes
according to EN 61000−3−2.
When controllers are installed into machines, commissioning (i.e. starting of the operation
as directed) is prohibited until it is proven that the machine complies with the regulations
of the EC Directive 98/37/EC (Machinery Directive); EN 60204 must be observed.
Commissioning (i.e. starting of the operation as directed) is only allowed when there is
compliance with the EMC Directive (2004/108/EC).
The controllers meet the requirements of the Low−Voltage Directive 2006/95/EC. The
harmonised standard EN 61800−5−1 applies to the controllers.
The technical data and supply conditions can be obtained from the nameplate and the
documentation. They must be strictly observed.
Warning: Controllers are products which can be installed in drive systems of category C2
according to EN 61800−3. These products can cause radio interferences in residential areas.
In this case, special measures can be necessary.
Transport, storage
Please observe the notes on transport, storage, and appropriate handling.
Observe the climatic conditions according to the technical data.