Lenze EPM−H315 - Manual (Page 62)

Commissioning
Project transfer to the operating unit
Disconnecting from the PC
5
l
62 EDBPM−H315 DE/EN/FR 7.1
0
F1 F2 F3 F4 F5
F6 F7 F8 F9 F10
Help
Info
shift
·
± space
V W X
7
M N O
4
A B C
0
D E F
1
G H I
2
J K L
3
Clr
Esc
P Q R
5
S T U
6
Y Z –
8
+ / -
9
Enter
PgUp
PgDN
ENTER to download
System autotest OK Boot forced
h315_007
How to download a project into the operating unit:
1. Switch on your PC and start the "HMI Designer" planning tool.
2. Switch on the supply voltage for the operating unit.
3. When the message ENTER to download" appears on the display, press the
enter key 0 of the operating unit.
The operating unit is ready to receive data when the message Boot forced"
appears on the display.
4. Load the desired project from the HMI Designer into the operating unit.
– See "HMI Designer − Getting started" Manual.
After the download, the operating unit is ready for operation and can exchange
data with other stations via the system bus (CAN).
5.2.3 Disconnecting from the PC
How to disconnect from the PC:
1. Switch off the PC.
2. Switch off the supply voltage for the operating unit.
3. Unplug the EPZ−H111 programming adapter from the operating unit and
the EPZ−H110 download cable from the PC.
4. Switch on the supply voltage for the operating unit.
The operating unit is now ready for operation.