Lenze 8250 series Brake unit - Manual (Page 29)

Installation
4-10 8250BA0903
4.3.5 Connect temperature monitoring
Danger!
The temperature monitoring is required to ensure safe switch-off
in the event of a failure.
Use the thermostats of the brake resistors to
• separate the controller from the mains if the temperature
monitoring is activated
and
• set controller inhibit in all connected controllers.
For connection of the thermostat: see the corresponding
signal-flow diagrams (chapter 4.3.2
¼ 4.3.4).
Show/Hide Bookmarks