Loadstar Sensors DI-1000U Digital Load Cell Interface Manual - Manual (Page 23)

DI-1000 Di1000 User Guide
Page: 23 / 25
P/N : 033-01591 Rev. 6
After connecting the DI-1000 a new port should appear:
In the above figure, COM22 corresponds to the virtual COM port of the DI-1000 Dongle.
Next, open Hyperterminal, and create a new connection corresponding to your attached DI-1000
device:
Select the COM port previously determined to correspond to the DI-1000:
Set the Baud Rate, parity, data bits, and number of stop Bits, as 9600-N-8-1. If you have a
DI-1000U-HS (high speed) modem, set the baud rate to 230400