Loadstar Sensors DI-1000U Digital Load Cell Interface Manual - Manual (Page 3)

DI-1000 Di1000 User Guide
Page: 3 / 25
P/N : 033-01591 Rev. 6
WARNING
1. Do not use the DI-1000 with the cover, or part of the cover removed or loose, as a
hazardous condition may result. Inspect the case for cracks or missing plastic. Do not
use if the display is damaged.
2. Use only AC Adapter Charger(s), which conforms to the display required voltage and
current ratings provided.
3. Do not operate the display in an explosive atmosphere, or in the presence of flammable
gases or fumes.
4. Do not immerse the display in liquid, the housing is not fluid-tight. Humidity
specifications are specified as non-condensing only.
5. Do not substitute parts or modify the display box to avoid the introduction of additional
hazards. Return the display to Loadstar sensors office for service and repair to insure
all safety features are maintained.
6. When the built in Li Ion Polymer battery option is present, take care not to:
a. Operate or store the display in temperatures beyond -20C to 60C. Battery failure
may occur.
b. Excessive barometric pressure changes may also cause the battery to fail or
outgas. This display is not to be used within a pressure vessel, for example.
c. Excessive physical damage, or severe product impact, may cause battery
failure. Physically damaged units should be returned to the factory for service
and repair.
ROHS/WEEE COMPLIANCE STATEMENT
EUROPE
Directive 2002/95/EC. Restriction of the Use of Certain Hazardous Substances in Electrical &
Electronic Equipment, as amended by EU Commission Decision 2005/95/EC.
This product is RoHS Compliant 2005/95/EC.
“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the
substances in excess of the maximum concentration values in EU Directive 2002/95/EC, as amended
by Commission Decision 2005/618/EC, unless the substance is in an application that is exempt under
EU RoHS. Unless otherwise stated by Loadstar sensors in writing, this information represents
LoadStar Sensors best knowledge and belief based upon information provided by third party suppliers
to LoadStar Sensors.
In the event any product is proven not to conform with LoadStar Sensors Regulatory Information
Appendix, then LoadStar Sensors entire liability and Buyer’s exclusive remedy will be in accordance
with the Warranty stated below.
WEEE Directive (2002/96/EC)
The Waste Electrical and Electronic Equipment Directive (WEEE) applies to companies that
manufacture, sell, and distribute electrical and electronic equipment in the E.U. It covers a wide range
of large and small household appliances, IT equipment, radio and audio equipment, electrical tools,
telecommunications equipment, electrical toys, etc.