MBT Lighting LEDSMARTSCAN (SRS-7001) User Manual
Page 3
Every DMX-controller has a different occupation with different features.
Addressing
The Control board allows you to assign the DMX fixture address, which is
defined as the first channel from which the scanner will respond to the
controller.
Please, be sure that you don’t have any overlapping channels in order to
control, each LED scanner correctly and independently from any other
fixture on the DMX data link.
If two, three or more LED scanner are addressed similarly, the will work
similarly.
For address setting, press the Menu button until the display shows A.001
and set the desired address via the up/down buttons.
Controlling:
After having addressed all LED Scanner, you may now start operating
these via your lighting controller.
Note: after switching on, the LED Scanner will automatically detect
whether DMX512 data is received or not. If the data is received, the
display will show “A.001” with actually set address. If there is no data
received at the DMX-input,. The display will show ”A 001”
The situation can occur if:
1, the 3Pin XLR plug(cable with DMX signal from controller) is not
connected with the input of the LED scanner.
2, the controller is switched or defective, if the cable or connector is
defective or the signal wires are swap in the input controller.
DMX-Protocol
Channel 1-Horizontal movement (Pan)
Push slider up in order to move the mirror horizontally (Pan)
Gradual mirror adjustment from one end of the slider to the other
(0-255,128-center)
The mirror can be stopped at any position you wish.
Channel 2-Vertical movement (Tilt)
Push slider up in order to move the mirror vertically (TILT)
Gradual mirror adjustment from one end of the slider to the other
(0-255,128-center)
The mirror can be stopped at any position you wish.
Channel 3 –COLORS
Value
Feature
0
14
WHITE
15
29
ORAGNGE
30
44
BLUE
45
59
GREEN
60
74
YELLOW
75
89
PINK
90
104
LIGHT BLUE
105
119
LIGHT GREEN
120
127
LIGHT YELLOW
128
255
RAINBOW EFFET SLOW-FAST