MK Diamond MK-101 Tracker - Manual (Page 13)

MK-101 TRACKER Revision 06/05, Effective Date June 07, 2005 Page 13
UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
ASSEMBLY:
Follow the assembly instructions to prepare your MK-101 TRACKER for operation.
1. Diamond Blade Installation:
NOTE: When installing the Retaining Screw, do not “cross-thread" and DO NOT over tighten the screw.
2. Movable Cutting Table Installation:
(A)
Remove the Movable Cutting
Table from the saw and raise
the Blade Guard
(C)
Depress and hold the Shaft Lock
pushbutton and remove Retaining
Screw and Outer Flange using
the Blade Wrench
(D)
Install Diamond Blade
onto Blade Shaft
(E)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct
(F)
Install Retaining Nut and Outer
Flange, depress and hold the
Shaft Lock pushbutton
and Tighten
Pivot Blade
Guard up Tighten
Wing-nut
Remove Movable
Cutting Table
Turn counter-
clockwise to
loosen
Press and
Hold
Retaining Screw
and Outer Flange
Diamond
Blade
Rotation Direction
Retaining
Nut and
Outer Flange
Rotate Blade
Wrench clockwise
to tighten
(B)
Locate the Shaft Lock
pushbutton on the underside
of the Cutting Head
Cutting
Head
Shaft Lock
Pushbutton
Blade
Wrench
Blade
Shaft
(A)
Align the four (4) wheels of the
Movable Cutting Table to the
saw Guide Rails
(B)
Seat all four (4) wheels onto the
Guide Rails
(C)
Verify movement of the Movable
Cutting Table
Wheel
Guide
Rail
Verify
movement Wheel
Guide
Rail