MK Diamond MK-101 Tracker - Manual (Page 28)

MK-101 TRACKER Revision 06/05, Effective Date June 07, 2005 Page 28
MAINTENANCE AND TROUBLESHOOTING
4. Flow Adjustment:
NOTE: If flow to the diamond blade requires adjustment, perform the following actions.
(J)
Lubricate the Cutting Head
Adjustment Knob
(I)
Remove the Cutting Head (See
Adjusting the Cutting Head)
(L)
Lubricate the Cutting Head
Pivot Shaft
(K)
Lubricate the Cutting Head
Adjustment Knob retaining holes
(D)
Increase cooling flow by
releasing the Flow Adjusting
Clamp
(E)
Reduce cooling flow by
Pressing down on the Flow
Adjusting Clamp
Cutting
Head
Adjustment
Knob
Retaining
Holes
Pivot
Shaft
Pull Tab
to loosen
Press Tab
to Restrict
Flow