MK Diamond MK-1503SS - Manual (Page 16)

16
Smoothing of the surface during the use of the coarse polishing discs will deter-
mine the quality of the finish that is achieved.
Once all of the large scratches and marks have been removed, use the finer grit
polishing discs (400, 800, 1800 and 3500) for a quality finish. For a higher luster/
color, finished surface, use the extremely fine 8500 grit polishing disc.
NOTE:
NOTE:
(A)
Place the ON/OFF Switch
in the ON position.
(D)
After working the area, shut
the water supply off.
(G)
Repeat Steps A through F
until all large scratches have
been removed.
(E)
Place the ON/OFF Switch
in the OFF position.
(H)
Change to fine grit discs for
a quality finish.
(F)
Dry surface then rub the surface
with a lumber crayon to deter-
mine the depth of the remaining
scratches.
(I)
Repeat Steps A through F using
fine grit discs to complete polish-
ing of the surface.
(B)
Adjust water flow
(excessive water flow can result
in internal electrical problems).
(C)
Using the coarse grit disc, re-
move all rough scratches
and cut marks.
Polishing Operation
MK-1503SS OPERATION