MK Diamond MK-2000 Pro - Manual (Page 13)

MK-2000 Pro Revision 01/02, Effective Date January 10, 2002 Page 13
UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
2. Adjustable Cutting Guide Installation:
NOTE: The Adjustable Cutting Guide can be used on either side of the Diamond Blade.
4. Diamond Blade Installation:
NOTE: When installing the diamond blade retaining-bolt, ensure the threads of the bolt are aligned with the
threads of the drive shaft so as not to “cross-thread" the bolt.
(A)
Loosen Adjustable Cutting
Guide retaining thumbscrew
(C)
Identify and remove Retaining
Screw and Outer Flange using
the Blade Wrench
(B)
Raise Cutting Head to the
highest position and tighten
the Locking Handle
Align
Parallel Slots
Ruler/Stop
Turn clockwise
to tighten
Seated
(B)
Position Adjustable Cutting
Guide above Movable Cutting
Table
(C)
Seat and tighten the Adjustable
Cutting Guide retaining
thumbscrew
Turn counter-
clockwise to loosen
(A)
Loosen the Cutting Head
Locking Knob
Locking Knob
Turn counter-
clockwise to loosen
Cutting Head
raised
Retaining Screw
and Outer Flange
Turn counter-
clockwise to
loosen
Blade Wrench
(D)
Install the Diamond Blade onto
Blade Shaft
(F)
Install the Retaining Screw and
Outer Flange and then tighten
(E)
Verify the Blade is seated on the
Blade Shaft and the Directional
Arrows are facing out
Install the
Blade
Rotate the Blade
Wrench clockwise
to tighten
Retaining Screw
and Outer Flange
Rotation
Direction
Seat Blade on
Blade Shaft