MK Diamond MK-2000 Pro - Manual (Page 29)

MK-2000 Pro Revision 01/02, Effective Date January 10, 2002 Page 29
MAINTENANCE AND TROUBLESHOOTING
6. Movable Cutting Table Wheel Change Out:
NOTE: All four (4) Movable Cutting Table, Roller Wheels should be replaced at the same time (MK Diamond
Part No. – 133090)
(B)
Place the Movable Cutting
Table on a Workbench with the
Roller Wheels facing up
(A)
Remove the Movable Cutting
Table
(E)
Install the Wheel/Washer
Assembly into Movable Cutting
Table Wheel Shaft Hole
(D)
Clean the Roller Wheel Shaft
Holes in the Movable Cutting
Table before installing new
Roller Wheels
Roller Wheels
Clean Holes
Movable
Cutting Table
(C)
Using a 1/2-inch wrench, remove
the Roller Wheel Retaining Nut
and the Roller Wheel
1/2-Inch Wrench
Washer
Roller Wheel
(F)
Install the Roller Wheel
Retaining Nut and tighten using
a 1/2-inch wrench
1/2-Inch Wrench
Rotate clockwise
to tighten
Rotate counter-
clockwise to loosen
(G)
Lubricate the Roller Wheels
using light oil
(Such as WD-40, 3 in 1, etc.)
Lubricate
Roller Wheels
(H)
Remove the Movable Cutting
Table
Movable
Cutting Table