MTS Acumen Electrodynamic Test System Load Frame User Guide - Manual (Page 31)

Electrical connections must be made by qualified personnel and conform to local codes and regulations.
Local electrical codes supersede any information found here.
MTS Acumen 3 MTS Acumen 1 Electrical Requirements
200-240 VAC 100-120 VAC (200-240) Voltage
50-60 Hz 50-60 Hz Frequency
10 Amp 7 (4) Amp Current
7
Single Single Phase
MTS Acumen Force Ratings
Note:
Specifications subject to change without notice.
Force Ratings
MTS Acumen 3 MTS Acumen 1 Specification
3000 N (670 lbf) 1250 N (280 lbf) Dynamic force
8
2000 N (450 lbf) 850 N (190 lbf) Static force
9
70 mm (2.76 in) 70 mm (2.76 in) Actuator dynamic stroke
10
>100 Hz >100 Hz Dynamic performance
7
MTS Acumen 1 current rated at 100 VAC. MTS Acumen 3 current rated at 200 VAC.
8
Verifiable with MTS compression spring test. Performance may vary depending on test type, test setup,
frequency, specimen, environment, and other factors.
9
Verifiable with MTS compression spring test. Performance may vary depending on test type, test setup,
frequency, specimen, environment, and other factors.
10
+/- 35 mm
MTS Acumen™ Electrodynamic Test System 31
Introduction