MTS Multipurpose Simulated - Manual (Page 39)

Description Parameter
acceptable because of the higher frequencies
of some tests.
Specify the voltage that is measured at this
load level. This parameter is used only for
FCG DCPD tests. FCG Measure Load Level
5.2.3.7.0 Enter Measured Crack Sizes
The software automatically enters the crack sizes from the end of the precrack activity and the crack sizes
from the end of the test. By default, the Precrack values are the last series of crack sizes measured during
the precrack activity and the Crack values are the last series of crack sizes measured during the test. These
crack sizes are used during data analysis. Optionally, you can change these values for the test run.
Measured Crack Size Parameters
Description Parameter
Specify the series of crack measurements made
at the end of the precrack activity. Precrack
Specify the series of crack measurements made
at the end of the test activity. Crack
5.2.3.8.0 End Simulation Test
To end the simulation test:
1. When finished with the test run, click Done in the main prompt menu.
2. Click HPU Power Off.
5.2.4.0 View Test Results
5.2.4.1.0 View Test Results
After the test run completes, you can view the test results.
1. In Explorer, click the name of the test run.
2. Click Results.
3. Click on the different tabs to view different types of results.
5.2.4.2.0 Fracture Test Results
The Test Results show the following information about the test run:
• Variable Summary shows all the parameters and their last values for the test run.
MTS TestSuite 39
5.0 Running Simulation Tests