New Era NE-1000 Multi-Phaser Programmable Syringe - Manual (Page 51)

New Era Pump Systems Inc.
www.SyringePump.com
Model NE-1000 Multi-Phaser™
Publication #1200-01 46 08/01/14
12.2 RS-232 Pump Network Connector Wiring
RS-232
To Network To Computer
PC Com Port Connectors
25 Pin 9 Pin
3 - Receive 2 - Receive Connect to pump TXD
2 - Transmit 3 - Transmit Connect to pump RCV
9 - Ground 5 - Ground Connect to pump GND
12.3 Accessories
12.3.1 ANA-BOX™
Part #: ADPT-ANABOX, Analog voltage control interface.
Allows the pump to be controlled by a variable voltage source. Creates a closed loop system allowing the
pump to be controlled by an external sensor, such as a pressure sensor, or other variable voltage source. Start
or stop the pump at a specific voltage level. Set the pumping rate to be proportional to the voltage input.
12.3.2 Syringe Heater
Part#: SYRINGE-HEATER, Visit www.SyringeHeater.com for details.
Flexible heating pad that wraps around the syringe. Thermo-Kinetic Heat Clamping digital controller will heat
a syringe to a set temperature up to 100 C.
12.3.3 RS-232 Network Cables
RS-232 Network Primary Cable
7 foot cable
Part #: CBL-PC-PUMP-7
25 foot cable Part #: CBL-PC-PUMP-25
Cable to connect a pump, or the first pump in a pump network, to a standard personal computer’s serial port
with a DB-9 or DB-25 connector. A 9 pin to 25 pin converter is available.
RS-232 Network Secondary Cable
7 foot cable
Part #: CBL-NET-7
25 foot cable Part #: CBL-NET-25
Cable to connect additional pumps, after the first pump, to the pump network.
USB to RS-232 Converter Cable
USB to RS-232 cable, software drivers on CD
Part#: CBL-USB232
Attached to the RS-232 Network Primary Cable, allows communication through a PC’s USB port.
RCV from network
TXD to network
TXD to computer
RCV from computer