MacDon Transport 30-36 ft and 39 ft 974 - Manual (Page 10)

TRANSPORT OPTION
Form # 46581 Issue 11/04 9
SET-UP INSTRUCTIONS
20. Install lights at R/H reel support arm using
1/2 x 1 inch carriage bolts and flange nuts
as shown.
NOTE: For headers with floating divider
option, a different light mounting bracket is
required. See instructions packaged with
dividers.
21. Install harness guard as shown at (A).
22. For 972 Headers: Install harness guard
holder (G) on reel arm as shown. Secure
holder with 5/8 x 1 inch hex head bolt and
lock nut.
23. Route harness up inside reel support arm
and over bolt (D). Pass harness through
guard to lights and make the connections.
Secure harness with plastic tie at (C) (see
inset, top photo).
NOTE: Wire colors do not match up when
connecting harness to lights. Refer to wiring
schematic on page 10.
24. For 972 single sickle drive headers: Attach
Slow Moving Vehicle sign to R/H endsheet
with spacer (between sign and endsheet), 3/8
x 1 ¾ carriage bolt and flange nut as shown
below left.
For 972 double sickle drive headers: If not
present, drill a 0.406” hole in R/H reel
support arm located 7 ½” (190 mm)
rearward of reel lift cylinder pin (F), and 3/8”
(10 mm) above center-line of reel lift cylinder
pin (F). Attach sign to reel arm with spacer
(between sign and arm), 3/8 x 1 ¾ carriage
bolt and flange nut as shown below center at
(E).
For 973 & 974 headers: Attach Slow Moving Vehicle sign to R/H reel support arm with spacer
(between sign and arm), 3/8 x 1 ¾ carriage bolt and flange nut as shown below right. For these
headers, harness guard holder (G) is not used. Position harness guard above SMV hardware to
secure back end.
G
D
INSTALL GUARD HOLDER - 972
A
INSTALL LIGHTS & HARNESS GUARD AT
R/H REEL ARM
C
E F
972 SINGLE SICKLE DRIVE 972 DOUBLE SICKLE DRIVE 973 / 974 HEADERS
INSTALL SMV SIGN