MacDon Transport 30-36 ft and 39 ft 974 - Manual (Page 6)

TRANSPORT OPTION
Form # 46581 Issue 11/04 5
SET-UP INSTRUCTIONS
8. Attach the four gauge wheels to hubs.
Torque wheel bolts to 80 to 90 ft. lbs. (110 to
120 N·m). Use the two longer wheel bolts
(9/16 NF x 1 ½”) to bolt handle to trans-axle
wheel.
9. At L/H support, install upper pin (A) in
desired stubble height position and secure
with split ring. When header is lowered,
spring-loaded bracket will engage upper pin
as shown below.
Push down on handle (B) and lock under
welded bolt head to raise pin (C) to allow
wheel to pivot. Pivot wheel to field position.
Release handle (B) from under bolt head to
lower pin (C) and lock in field position.
10. At R/H support, install upper pin (D) in
desired stubble height position and secure
with split ring. When header is lowered,
spring-loaded bracket will engage upper pin.
Push down on handle (F) and lock under
welded bolt head to raise pin (G) to allow
wheel to pivot. Pivot wheel to desired field
position. Release handle (F) from under bolt
head to lower pin (G) and lock in field
position.
NOTE: Wheel can be positioned on either
side of support, depending on delivery
opening position. (See Step 5.)
NOTE: Install the two decals provided on the
inboard face of left and right frame legs as
shown below. The decals indicate proper pin
position for storage, different levels of stubble
height, and transport.
STEP 8:
HANDLE BOLTS TO TRANS-AXLE WHEEL
A
B
L/H WHEEL SUPPORT: FIELD POSITION
C
D
F
G
R/H WHEEL SUPPORT: FIELD POSITION
DECAL PLACEMENT
LEFT FRAME LEG
DECAL PLACEMENT
RIGHT FRAME LEG