MacDon Transport 30-36 ft and 39 ft 974 - Manual (Page 18)

TRANSPORT OPTION
Form # 46581 Issue 11/04 17
CONVERTING FROM TRANSPORT TO
FIELD POSITION (continued)
8. Detach diagonal brace from strut channel at
(A) and remove brace head from cutterbar.
Remove pin (B) from transport position.
9. Disengage strut hook from cutterbar and
pivot strut channel down to collapsed
position on the trans-axle. Install pin (B) in
storage position (through hole D in above
photo) and secure with split ring.
NOTE: Install pin so head is on correct side
for storage of trans-axle wheel. See Step 11.
10. At R/H support, install upper pin (D) in
desired stubble height position and secure
with split ring. When header is lowered,
spring-loaded bracket will engage upper pin.
Push down on handle (F) and lock under
welded bolt head to raise pin (G) to allow
wheel to pivot. Pivot wheel to desired field
position. Release handle (F) from under bolt
head to lower pin (G) and lock in field
position.
NOTE: Wheel can be positioned on either
side of support, depending on delivery
opening position.
A
B
D
STEP 8: DETACH BRACE FROM STRUT
& REMOVE PIN
STEP 9: DETACH STRUT HOOK
D
F
G
STEP 10: R/H FIELD WHEEL