MacDon Transport 30-36 ft and 39 ft 974 - Manual (Page 7)

TRANSPORT OPTION
Form # 46581 Issue 11/04 6
SET-UP INSTRUCTIONS
11. Roll the trans-axle to the rear of the header.
Lift and engage head of hitch pin (C) in notch
of storage latch.
12. Lower header onto gauge wheels.
13. Check tire pressure. Inflate to 100 psi (690
kPa).
14. Place hitch in storage on back tube: At left
endsheet, install storage support (D) with ½ x
1 short neck carriage bolt and flange lock
nut.
NOTE: Orient support (D) for best clearance
of tow pole to header hoses, etc. in storage.
Lay hitch clevis over storage support (D) and
secure with hitch pin and lynch pin. At
inboard end, attach support (E) to header left
leg with two ½ x 1 carriage bolts and flange
nuts. Rest hitch in support (E). Secure hitch
chain and electrical harness at bracket (F) as
shown. Use the locking device on hitch chain
to secure the hook.
C
STEP 11:
PLACE R/H WHEEL IN STORAGE
D
STEP 14: HITCH STORAGE AT ENDSHEET
F
STEP 14: CHAIN & HARNESS STORAGE
E
STEP 14: HITCH STORAGE AT LEG