MacDon Transport 30-36 ft and 39 ft 974 - Manual (Page 19)

TRANSPORT OPTION
Form # 46581 Issue 11/04 18
CONVERTING FROM TRANSPORT TO
FIELD POSITION (continued)
11. Roll the trans-axle to the rear of the header.
Lift and engage head of hitch pin (C) in
notch of storage latch.
NOTE: Trans-axle can be positioned on
either side of leg, depending on delivery
opening position.
12. Lower header to cutting height and move
reel to desired operating position. For
manual fore-aft: To avoid binding, move reel
two positions at a time, alternating sides so
reel moves back evenly.
13. Place hitch in storage on back tube: At left
endsheet, lay hitch clevis over storage
support (D) and secure with hitch pin and
lynch pin. At inboard end, rest hitch in
support (E). Secure hitch chain and
electrical harness at bracket (F) as shown.
Use the locking device on hitch chain to
secure the hook.
STEP 11:
TRANS-AXLE WHEEL STORAGE
C
D
STEP 13: HITCH STORAGE AT ENDSHEET
E
STEP 13: HITCH STORAGE AT LEG
F
STEP 13: CHAIN & HARNESS STORAGE