Schwank ultraSchwank EIH - Manual (Page 16)

16
UHE-F / EIH-F I&O Manual
IM100205
RD: MAY 2014
RL: 06A
 Locate the second hanger within 6 to 24 inches (15 to 60 cm) from the swaged end
of the tube
 Result: The first and second hangers are spaced apart within 86 to104 inches (218
to 264 cm)
4) Insert the swaged end of the first tube (tube with flange) through and on to the second
hanger with the WELDED SEAM OF THE TUBE AT THE SIDE OR FACING DOWN
5) Insert the flanged end of the tube through and on to the first hanger . Position the tube so
that the first hanger is 6 inches (15 cm) from the tube flange
 Check that the first tube is level - make adjustment to hanger height accordingly
6) At the swaged end of the tube, slide a Torctite tube coupler past the swage on to the tube
 Special condition: 160,000 & 200,000 Btuh models - first, second (and third
200,000) tube joints - See Sections 9.1 & 9.2 & FIG 13 NOW
 The final position of the coupler will be between the second and third hangers
7) Install a reflector over the first tube: Ensure that the end with the extended inner reflector is
located toward the burner
 Insert reflector through the second ‘downstream’ hanger first, then slide back into the
first hanger
 The downstream end of the first reflector should be located at the center of the first
tube coupler
8) At the FIRST REFLECTOR, FIRST and SECOND hangers ONLY: (see FIGURE 8 below)
 Install hanger clips (4 supplied) on hangers - one on each side of first two hangers
 Position the hangers perpendicular (at right angle) to the tube and reflector.
 Using sheet metal screws provided, fasten the hanger clips to each side of reflector
9) At ALL other reflectors and hangers: Orient the hanger perpendicular to reflector - DO NOT
fasten to reflector. Allows reflector system to expand in length through hangers.
Install a hanger clip (4 sup-
plied) on to each side of
first and second hangers.
Position hangers perpen-
dicular to reflector.
Fasten hanger clips to
outer reflector with sheet
metal screws (provided)
each side of reflector.
FIGURE 8 FASTEN FIRST TWO HANGERS TO FIRST REFLECTOR (ONLY) - Each Side
ONLY
… and
this side
also