Schwank Parasol Series Post Mount 24 volt User Manual
Page 22
4BN/L6-24,4SN/L5 -24 Manual
IM100310
RD: MAR, 2010
RL: 1A - BA
22
OVERVIEW
The remote control hand set is used to turn patio heaters ON and OFF from a distance of up to 25
feet.
Heaters must have a 24V Direct Spark Ignition system designed for automatic control.
One Transmitter Hand Set can control up to 16 individual heaters (receivers) or 16 zones of heat-
ers.
¨ An ‘On-Off’ button must be pressed and held for 2 (two) seconds to activate the
heaters/receivers.
¨ There is a ‘purge cycle’ time delay of up to 30 seconds before the heater will ignite.
¨ We recommend that any patio site have at least two Transmitter Hand Sets regard-
less of the number of heaters – one hand set is a secure back-up if the other is mis-
placed or malfunctions.
PROGRAMMING / SET UP (Read this section prior to installation of receivers).
Follow the instructions below to set each receiver to the correct House & Unit Codes.
Complete the “Patio Floor Plan sketch and Settings Table” on page 26 of this manual to
assist you in the set up process
.
Refer to the wiring diagrams in this manual for electrical connection of the receiver to the
heater ignition system.
NOTE: THE LETTERS OR NUMERALS ON THE HOUSE CODE AND UNIT CODE ‘DIAL
FACES’ INDICATE EVERY OTHER OR ‘ODD’ SETTING POSITIONS (A, C, E,…) & (1, 3, 5, …).
THE ‘EVEN’ POSITIONS (B,D,F,..) & (2,4,6,…) ARE REPRESENTED BY A DOT .
Setting the House Code –
Adjust with slot screw driver
Set the same “house
code” on the transmitter and any/all receivers (heaters) that it is in-
tended to control (
16 codes available A to P). e.g.: If a hand set transmitter is set to house code
“B”, all receivers set to house code “B” will be controlled by that transmitter.
The ‘house Code’ ensures that there will be no interference with any neighboring remote con-
trolled appliances. This includes the setting of unique House Codes on multiple Transmitter Hand
Sets used to control different zones of heaters at one site.
CAUTION:
For safety, switch off main power before connecting, disconnecting or servicing.
DO NOT OVERLOAD
Do not place two receivers closer than 1 meter apart.
Do not use near flammable liquids / vapours (solvents, thinners).
CODE SWITCHES:
Adjustable with ‘slot’ type screw driver
· House Code: A to P: Allows interference-free programming unique
from that of a neighboring system; allows use of separate transmit-
ter hand sets to control different patio areas at the same site
· Unit Code: 1 to 16: Unit Code matches to individual ’On-Off’ but-
tons and Group Selection switch on hand set transmitter; Individual
code for each receiver (or zones of heaters / receivers)
OPERATION:
On-Off function with maximum loading of 7 Amps
House
Code
Unit
Code