Important notice to installer, Important safety notices and warnings, Warning – Schwank Parasol Series Post Mount 24 volt User Manual

Page 4

Advertising
background image

4BN/L6-24,4SN/L5 -24 Manual

IM100310

RD: MAR, 2010

RL: 1A - BA

4

Important Notice To Installer:

Installation and repairs must be done by a trained gas service technician.
This Operation & Instruction manual is not to be removed from the site. This manual
MUST be given in its entirety to the consumer and retained for future reference. Ac-
quaint the end user with Important Information throughout the manual.

IMPORTANT SAFETY NOTICES AND WARNINGS:

Warning



Improper Installation, adjustment, alteration, service or maintenance
can cause injury or property damage.



READ the installation, operating and maintenance instructions thor-
oughly before installing or servicing this equipment.



It is imperative that control compartment, burners and circulating air
passageways be kept clean and unobstructed.

Warning

Clearance to Combustibles

Do not use, store or locate flammable or explosive objects, liquids or vapors in

proximity of the heater. Location of flammable or explosive objects, liquids or va-
pors close to the heater may cause fire or explosion and result in property dam-
age, injury or death.

The clearance to combustible material represents the minimum distance

that must be maintained between the outer heater surface and a nearby

surface. The stated clearance to combustibles represents a surface tem-

perature of 90F° (50C°) above room temperature.

It is the responsibility of the installer and end user to ensure that build-

ing materials with a low heat tolerance which may degrade at lower tem-

peratures are protected to prevent degradation. Examples of low heat

tolerance materials include vinyl siding, fabrics, canvas, plastics, filmy

materials, tri-ply, etc.

 In addition to stored or stationary material, clearance consideration must also be given to

moveable objects such as furnishings and vehicles, and structural objects such as electrical
and gas lines, electrical fixtures, and sprinkler heads.

 Heaters must be located an appropriate distance from sprinkler heads. This distance may be

greater than the certified clearance to combustibles. Check the temperature rating of the sprin-

Advertising