Schwank Parasol Series Post Mount 24 volt - Manual (Page 23)

4BN/L6-24,4SN/L5 -24 Manual
IM100310
RD: MAR, 2010
RL: 1A - BA
23
Setting the Unit Code –
Adjust with slot screw driver
The Transmitter Hand Set has a ‘Group Selection’ slide switch
with 4 settings (I, II, III, IV) and 4 sets ‘On-Off’ buttons (1, 2, 3,
4
).
Hence there are four ‘On-Off’ buttons for each Group Setting
and a total of 16 ‘On-Off’ functions on the Hand Set.
see table —>
Each receiver has 16 unique ‘Unit Codes’ (numerals 1 to 16).
The “Corresponding Settings” table (to the right —>) indicates
the receiver setting that corresponds to each combination of
Group switch and On-Off button on the Transmitter Hand Set.
Set a different ‘Unit Code’ on each receiver so that the Transmit-
ter Hand Set can control up to individual 16 heaters.
NOTE: Within any zone of a patio best comfort is provided by
the operation of two (or more) opposing heaters. All receivers
(heaters) located in in the same ‘comfort zone’ can be set to the same ‘Unit Code’. All heaters in
a common ‘comfort zone’ are thereby activated simultaneously by one common ‘On-Off’ switch.
(There is no limit to the number of receivers that can be set to the same Unit Code.)
CORRESPONDING SETTINGS
RECEIVER TRANSMITTER
UNIT
CODE
GROUP
SELECTION
ON-OFF
BUTTON
1 I 1
2 2
3 3
4 4
5 II 1
6 2
7 3
8 4
9 III 1
10 2
11 3
12 4
13 IV 1
14 2
15 3
16 4
Also see next page for a description of setting codes in graphic format.
Complete the “Patio Floor Plan sketch and Settings Table” on
Page 26 of this manual to assist you in the set up process.