SDC E5 Series Access Control System - Manual (Page 12)

SET READER PARAMETERS
Select System
Select Set Reader Parameters (1-2)
The Reader Parameters tab (1-2-1) will be displayed by default.
Use this menu to add and delete readers as well as setting their basic operation parameters.
Select Add to display the above screen. Enter the following information :
Name : Enter a name that describes where the reader is in the building.
Location : Where is the system located. Use this field to mark remote locations.
Module : Type of reader (Leave as E5).
Com Port : Select the physical Com Port that connecting the PC to the reader.
Terminal Number : Select the number (01 to 99) that matches the terminal address that you
programmed into this reader. *
*Note: Each reader must have it’s own unique terminal number
Select Save to add the reader to the system. The new reader will appear on the left.
You can edit this reader in the future by selecting the reader from the window on the left, then
selecting Edit
. To remove a reader, select the desired reader and press Delete .
P:\Installation Instructions\Access Controls\Inst-E5\INST-E5.vsd Rev C 03-13 Page: 9